Search:

Type: Posts; User: Daydreamer; Keyword(s):

Page 1 of 19 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    286
    Views
    41,796

    Well done! Welcome back.

    Well done!
    Welcome back.
  2. Replies
    22
    Views
    1,146

    This just in from HMB YC We are looking...

    This just in from HMB YC

    We are looking forward to seeing you all Saturday!

    Well, our clubhouse remains closed, but we will have the bathrooms and showers open for you (access is in the rear...
  3. Replies
    22
    Views
    1,146

    Half Moon Bay Yacht club is closed. Anchor out...

    Half Moon Bay Yacht club is closed.

    Anchor out in the inner harbor.

    Pillar Point Harbor slips available on first come first serve basis.
    VHF ch. 74
    Ph. (650) 726 4382

    Ketch Joan, Half Moon...
  4. Replies
    3
    Views
    417

    Don't trust your brain to remember the proper...

    Don't trust your brain to remember the proper co-ordinate to turn around.
    After a couple days of being seasick, every longitude looks like the turn around!

    5610

    Make a note! Write it in...
  5. Thread: Surprise!

    by Daydreamer
    Replies
    389
    Views
    121,839

    Great stuff Bob The sole finished out...

    Great stuff Bob

    The sole finished out beautifully.

    That plotter will be handy when finishing in Hanalei,
    In the middle of the night,
    In a squall.

    iPads don't like to zoom with wet hands :(
  6. Replies
    286
    Views
    41,796

    The Kennedy Meadows Resort & Packstation is...

    The Kennedy Meadows Resort & Packstation is located in the Stanislaus National Forest about 60 miles East of Sonora, Ca. and 10 miles West of the Highway 108 junction with the Pacific Crest Trail.
    ...
  7. Replies
    2
    Views
    555

    I've used the setup that has the fly mounted...

    I've used the setup that has the fly mounted under the antenna base and the vane on the whip.
    Worked well on the Oday 22. Might have been the Davis brand.
  8. Thread: Hedgehog

    by Daydreamer
    Replies
    61
    Views
    10,276

    Congrats on getting Hedgehog back in order!!

    Congrats on getting Hedgehog back in order!!
  9. Replies
    6
    Views
    790

    As long as the brakes are operating and not...

    As long as the brakes are operating and not pulling to one side or the other, I think the rust causing the surge will diminish until gone with several stops.
    If it gets better with a few stops I...
  10. Replies
    9
    Views
    1,174

    I have a small 20# mushroom with 50 feet of 3/8...

    I have a small 20# mushroom with 50 feet of 3/8 braided line.
    Probably too light for DuraMater, but youíre welcome to try it.

    You canít see the numbers on the scale, but it gives you an idea of...
  11. Replies
    286
    Views
    41,796

    I'm wondering if there might be a leverage...

    I'm wondering if there might be a leverage problem rather than friction.

    Have you tried a longer arm on the oar?

    Maybe 2:1 purchase on the lines to the oar.

    Of course I don't know how far...
  12. Replies
    533
    Views
    168,536

    Looks like a fun boat. Keep it up!!

    Looks like a fun boat.

    Keep it up!!
  13. Thread: Surprise!

    by Daydreamer
    Replies
    389
    Views
    121,839

    Nice work! Likely that spot was bleached from...

    Nice work!

    Likely that spot was bleached from something spilling on it.

    Might try a bit of oil based stain to darken the teak area.

    Tedious work with a small brush.

    Not sure what do do...
  14. Replies
    3,955
    Views
    2,284,342

    I enjoyed Farley's "Grey Seas Under" Tales of...

    I enjoyed Farley's "Grey Seas Under"
    Tales of FOUNDATION FRANKLIN. A coal burning salvage tug out of Nova Scotia.

    And we think we've done some stuff!
  15. Replies
    3,955
    Views
    2,284,342

    Patience pays. 5390

    Patience pays.

    5390
  16. Replies
    2
    Views
    742

    Rule 3.17 states "A boat shall have a knot meter"...

    Rule 3.17 states "A boat shall have a knot meter"

    You don't necessarily need a thru-hull.
    Mounting a paddlewheel to an L-bracket from the transom would work.
    Or use a taffrail log.

    I heard a...
  17. Replies
    3,955
    Views
    2,284,342

    #6 Though I haven't found it specifically I...

    #6 Though I haven't found it specifically I believe a type of mite could make a home upon the plastic.

    #4 There is a particular cold molded Express 27 that is the original mold for subsequent...
  18. Thread: Greg Ashby

    by Daydreamer
    Replies
    1
    Views
    769

    Hi Joe, You can reach me at gca at goldrush dot...

    Hi Joe,
    You can reach me at
    gca at goldrush dot com
  19. Thread: Surprise!

    by Daydreamer
    Replies
    389
    Views
    121,839

    I would go the planer, sander route, the old...

    I would go the planer, sander route, the old veneer is probably only 1/32 thick.
    If it's not delaminating you could sand off the finish and glue on the new veneer and finish.
    Of course to save...
  20. Thread: Surprise!

    by Daydreamer
    Replies
    389
    Views
    121,839

    If the plywood isn't delaminating you could epoxy...

    If the plywood isn't delaminating you could epoxy new veneer.
    I don't know this company. Just something I found.
    https://www.oakwoodveneer.com/teak-and-holly-veneer.html
  21. Thread: Seventy48

    by Daydreamer
    Replies
    14
    Views
    4,626

    Thanks Alan! That inspires some ideas. Take the...

    Thanks Alan!
    That inspires some ideas.
    Take the seat out of the canoe, park it in the living room, a few bits, some blocks....
    Let's see what I come up with!
  22. Replies
    143
    Views
    59,200

    Wonderful looking kit! Keep us posted.

    Wonderful looking kit!
    Keep us posted.
  23. Thread: Seventy48

    by Daydreamer
    Replies
    14
    Views
    4,626

    As things stand right now, our local lakes and...

    As things stand right now, our local lakes and parks are closed, so I haven't been out for training in a while.
    Gyms are closed.
    I don't own a Concept 2 rowing machine.

    Currently thinking about...
  24. Thread: Seventy48

    by Daydreamer
    Replies
    14
    Views
    4,626

    The latest update from race central; "Over...

    The latest update from race central;

    "Over here at Races High Command we turn on every computer monitor and radio, set them all to news stations and spin in circles until we find a station that is...
  25. Replies
    23
    Views
    4,411

    Let's hang in there and see if things open up!

    Let's hang in there and see if things open up!
Results 1 to 25 of 454
Page 1 of 19 1 2 3 4